• 产品特点
  • 技术规格

 单缸、四冲程、水冷、电脚启动发动机

 通过燃烧分析、优化S/D比、点火曲线,确保燃烧更充分,性能较同类产品提高8-10%,且有效降低超越离合器故障

 采用离心缸套技术,缸套同铝合金接触面积增加1.5倍,强度和寿命提升2倍

 采用双PVD活塞环,硬度提高30%,提高耐磨性,有效减少烧机油、机油消耗快现象

 采用外置脚起动结构,彻底解决市场痛点(铜套磨损)

 采用碳纤摩擦片+压盘嵌钢片结构,抵墙冲击次数增加2倍

 采用大容量多级过滤技术,提升70%净化能力,寿命增加2倍

 采用水道优化+大水泵+大水管结构,流量提升60%

 采用两侧放油结构,保养更简便

 强化挡齿,强度提升30%

 强化副轴轴承,外径增大至φ33,寿命提升35%

 

 Single cylinder, four stroke, water cooled, electric start engine.

 Through combustion analysis, optimization of S/D ratio, ignition curve, to ensure more full combustion, performance is improved by 8-10% compared with similar products, and effectively reduce overrunning clutch failure.

 Using centrifugal cylinder liner technology, the contact area between cylinder liner and aluminum alloy is increased by 1.5 times, and the strength and life are increased by 2 times.

 The use of double PVD piston ring, hardness increased by 30%, improve wear resistance, effectively reduce the burning oil, oil consumption phenomenon.

 External kick starting structure, completely solve the market pain points (copper sleeve wear).

 Carbon fiber friction plate + platen embedded steel plate structure, the impact times against the wall increased by 2 times.

 Using large capacity multistage filtration technology, improve the purification capacity by 70%, and increase the life by 2 times.

 Waterway optimization + large water pump + large water pipe structure, the flow rate increased by 60%.

 The use of two sides of the oil discharge structure, easier maintenance.

 The counter shaft bearing is strengthened, the outer diameter is increased to φ33, and the service life is increased by 35%.

 Strengthened counter shaft bearing, outer diameter increased to φ33, life increased by 35%.

外特性曲线 WIDE OPEN THROTTLE CURVES(TT210A水冷)  

外特性曲线 WIDE OPEN THROTTLE CURVES(TT260A水冷)  

外特性曲线 WIDE OPEN THROTTLE CURVES(TT300A水冷)  

悬挂图 INSTALLATION DIMENSIONS

Copyright ? 2014 loncinengine.com All Rights Reserved
电话:400 636 9980 地址:重庆市九龙坡区九龙工业园C区聚业路116号 邮箱:Engine_loncin@sina.com 传真:86 23 8669 3433